dumpstool logo
An image of the volume past is expiration date or has reached its maximum number of mounts is no longer available for restores.
A job fails with the following message:
The administrator verifies the default OS host name resolution order is in place in all the environments, but finds an incorrect entry for the client in the media server's hosts file and corrects it. The hosts file on the client is properly configured. The administrator restarts the job, but the job fails with the same error message.
Which action should the administrator perform to ensure the job completes successfully?
What is the state of the catalog backup media after successful completion of a catalog recovery using the Catalog Recovery Wizard?
Where is the option to allow communication with NetBackup 8.0 and earlier hosts without certificates?
Backups to a storage device fail with the following error message:
Disk storage server is down (2106)
The storage server is an OpenStorage (OST) host, and the master server and media server are both acting as media servers under Credentials > Storage Servers in the NetBackup Administration Console. The disk pool is in an Up state and the storage server is in a Down state. Troubleshooting confirmed the OST plug-ins on the servers are mismatched.
Which command should an administrator use to check the plug-in version installed on the servers?
Which command can an administrator run to test and analyze connections between master servers, media servers, and clients for multiple NetBackup ports?
Refer to the exhibit.
A backup policy uses a Full backup schedule with a schedule type of Frequency: 1 day. The start window for the schedule is configured as shown in the exhibit:
The administrator runs a manual backup at 10:00 on Thursday.
When will the next backup run, if all prior backups completed successfully?
When an administrator creates a duplicate copy of an image, what will the retention be for the new copy?
An administrator is experiencing a backup failure, which may be due to lack of connection between the media and master server. The status of the media server is shown below:
Media server showing offline
Which command can the administrator run to change the status of the media server?
What is the correct order in which to configure deduplication storage in NetBackup?
An administrator has a master server running over 50,000 jobs per day.
What can the administrator do to reduce the load on the master server?
Which step must an administrator complete prior to configuring a new NBU-Catalog policy?
NetBackup has frozen some of the tapes added to the robot.
Which log must be enabled to determine why the tapes were frozen?
A tape library had the robot firmware upgraded, and now the robot is reading the barcodes with additional characters.
How should an administrator enable NetBackup to use the same characters that were used before the firmware upgrade?
Prior to initiating a restore, an administrator realizes that media needed for the restore was written by a server that is unavailable. The administrator does have another server that can perform the restore and that is connected to the same library.
Which two commands can the administrator perform to change the server ownership, so the restore can be performed? (Choose two.)
Which two NetBackup features are available to protect the MSDP catalog? (Choose two.)
What is the certificate deployment and management behavior when the security level is set to High?
TESTED 23 Dec 2024